Home › Forums › KISS Racing Line › Kiss 24a RE Revo Tagged: D-shot, ESC, F3, F4, Revo This topic contains 3 replies, has 3 voices, and was last updated by Dave 4 months, 1 week ago. Viewing 4 posts - 1 through 4 (of 4 total) Author Posts 9. January 2017 at 19:50 #2365 ianolo80Participant Hi Guys, I currently run a F3 non kiss board with kiss 24a ESC’s, I’m looking to upgrade to the new F4 Revo running Betaflight but I want to use the new 24a RE ESC’s and I want to run D-Shot 600, if I flash the ESC’s to 1.03h will it work? Regards, Ian 9. January 2017 at 22:20 #2367 retinexParticipant Hi, same for me, would like to use also f4 revo with dshot. How are you able to upgrade 1.03h or 1.08f firmware to the 24a kiss esc without having your kiss fc? my kiss are now 1.02 (upgrade it via stm32flash) yours, Manuel 9. January 2017 at 23:49 #2371 ianolo80Participant Just Upload it like you do 1.02 i think, using the STM32 Flasher or if you do a bit of digging there is a firmware flasher for the escs that loads through you web browser, but couldnt get it to work. 12. January 2017 at 8:49 #2374 DaveParticipant Hm, be aware: I had no luck upgrading from 1.03 to 1.08f with Betaflight’s ESC passthrough method over PWM and no luck with the STM32 Demonstrator GUI over FTDI either. See http://kiss.flyduino.net/forums/topic/upgrade-esc-without-kiss-fc/#post-2372 5 of my ESCs are in a coma right now… Author Posts Viewing 4 posts - 1 through 4 (of 4 total) You must be logged in to reply to this topic.