Dshot 600 / 300 / 150 for Flyduino KISS FC & ESC

Dshot600 for KISS FC and ESCs is already working well Dshot compatible KISS Hardware Flyduino KISS FC v1.03 Flyduino KISS ESC 24A Here are some articles and informations about Dshot General InfoRead More…

Calibrating ESCs through the GUI

With version v1.0.12 of the Chrome App GUI and firmware RC28 you can calibrate the throttle range of your ESCs by following these simple steps: Remove props first! Unplug the lipo Click “TEST”Read More…

KISS ESC24A re Reviews

Collection of external KISS ESC24Are Reviews KISS 24A ESC Race Edition – Review, Setup, Guide New KISS ESC 24A Race Edition announced  

KISS PDB 24a ESC Carrier

The KISS Carrier Board  This item allows a super clean and compact build of the power supply and flight controller wiring. 4 KISS 24a RE ESCs can be mounted directly on the PDB. TheRead More…

How to flash the 24a Race Edition ESC

Flashing the KISS ESC 24A Connect the USB-UART to one ESC (RX-TX TX-RX and GND-GND) Unmount all propellers! Connect the USB- UART to your computer and then power the ESC. Wait 5secondsRead More…

Issues with the 24a Race Edition ESC?

After powering up the KISS ESC (with a LiPo battery) the LED lights up for roughly half a second and the motor will beep (high-low-high). This indicates that the ESC receives aRead More…

KISS 24a Race Edition ESCs

ESC Breakdown             Solder contacts for motor-phase connections LiPo Power supply GND – LiPo Power supply + PWM signal input (servo signal) PWM signal GND (ground reference)Read More…